SURFACE PREPARATION

Concrete Surfaces:
Surfaces to be treated must be free from oil, dust, dirt, and contaminants.
Loose particles, cement laitance, and any materials preventing adhesion must be removed.

Metal Surfaces:
Surfaces to be primed must be thoroughly cleaned of rust, mill scale, dirt, dust, oil, and grease.

MIXING INSTRUCTIONS

Component A and Component B must be mixed according to the specified mixing ratio using a low-speed mixer for at least 3–4 minutes until a homogeneous mixture is obtained.
After mixing, the material is ready for application.

COATING SYSTEM

Concrete substrates must be primed with SC 215 Solvent-Free Epoxy Primer or SC 270 Low Viscosity Epoxy Impregnation Primer.
For damp substrates, SC 220 Epoxy Primer for 100% Damp Surfaces must be used.

Application of the topcoat may be carried out after the primer has cured (12 hours at 25°C).
For brush or roller applications, epoxy-specific rollers must be used.

Where high UV resistance is required, application of PU 125 Protective Coating at a consumption rate of 0.150–0.200 kg/m² is recommended.

APPLICATION CONDITIONS

• Avoid application below 5°C and in very humid environments.

• Mixing ratios must be strictly observed.

SAFETY

This product is intended for professional use only.
Before use, carefully read the safety instructions on the packaging and consult the Material Safety Data Sheet (MSDS) if required.
Do not inhale vapors; avoid contact with skin and eyes; do not ingest.
Use appropriate personal protective equipment.
Take necessary precautions against fire, explosion, and environmental contamination.
Apply only in well-ventilated areas.

TRANSPORT & STORAGE

• Store between 5–35°C.

• Protect from direct sunlight and frost.

• Store opened products in their original packaging with the lid tightly closed.

NOTES

BRV reserves the right to make improvements and/or revisions to the product and this technical document over time.
This Technical Data Sheet supersedes all previously issued versions for this product and is valid for 5 years.
Users must ensure that they are using the most current version of this document and should contact the manufacturer if necessary.
Correct use of the product, application conditions, and application methods are the responsibility of the applicator.
BRV Epoxy Paint accepts no liability for consequences arising from improper application, work accidents, or any direct or indirect damage or loss.
The packaging values stated above are nominal values based on standardized formulations. Minor variations may occur under normal production conditions in accordance with international standards.